Advanced
search

To read this content please select one of the options below:

Experimental investigation of microdrilling of printed circuit board

Xiaohu Zheng (School of Mechanical Engineering, Shanghai Jiao Tong University, Shanghai, China)
Zhiqiang Liu (School of Mechanical Engineering, Shanghai Jiao Tong University, Shanghai, China)
Qinglong An (School of Mechanical Engineering, Shanghai Jiao Tong University, Shanghai, China)
Xibin Wang (School of Mechanical Engineering, Beijing Institute of Technology, Beijing, China)
Zongwei Xu (College of Precision Instrument and Opto‐electronics Engineering, Tianjin University, Tianjin, China)
Ming Chen (School of Mechanical Engineering, Shanghai Jiao Tong University, Shanghai, China)

Circuit World

ISSN: 0305-6120

Article publication date: 10 May 2013

335

Abstract

Purpose

–

The purpose of this paper is to investigate the cutting mechanism of drilling printed circuit board (PCB) and to optimize the drilling parameters for decreasing burr size and thrust force.

Design/methodology/approach

–

An experimental study was carried out to investigate the effect of drilling parameters on thrust force and burr formation. The drilling process of PCB was divided by the variation of drilling force signals. Analysis of variance (ANVONA) was carried out for burr size and thrust force. Desirability function method was used in multiple response optimization, to find the best drilling parameters.

Findings

–

Enter burr and exit burr have different morphologies and types. The generation of enter burr is mainly caused by burr bending which can be observed in micrographs, whereas the generation of exit burr is more complicated than enter burr; both burr breakup and burr bending are observed in exit burrs. In the selected area, the optimized spindle speed and feed rate for drilling PCB is 12 krev/min and 6 mm/s, respectively.

Research limitations/implications

–

In this paper, hole wall roughness and tool wear were not considered in the optimization of drilling parameters. The future research work should consider them.

Originality/value

–

This paper investigates the mechanism of burr formation and thrust force in drilling PCB and then optimizes the drilling parameters to decrease the burr formation and thrust force.

Keywords

Citation

Zheng, X., Liu, Z., An, Q., Wang, X., Xu, Z. and Chen, M. (2013), "Experimental investigation of microdrilling of printed circuit board", Circuit World, Vol. 39 No. 2, pp. 82-94. https://doi.org/10.1108/03056121311315800

Publisher

:

Emerald Group Publishing Limited

Copyright © 2013, Emerald Group Publishing Limited

Related articles

Manage cookies

We’re listening — tell us what you think

Join us on our journey