To read this content please select one of the options below:

Process characterization and reliability for the assembly of 01005 chip components

Yong‐Won Lee (Packaging Engineering, Advanced Semiconductor Engineering Korea Inc., Gyeonggi‐Do, South Korea)
Keun‐Soo Kim (Fusion Technology Lab., Hoseo University, Chungnam, South Korea)
Katsuaki Suganuma (Institute of Science and Industrial Research, Osaka University, Osaka, Japan)

Soldering & Surface Mount Technology

ISSN: 0954-0911

Article publication date: 20 September 2011

450

Abstract

Purpose

The purpose of this paper is to optimize assembly processes in order to minimize defects in the assembly of 01005 chip components.

Design/methodology/approach

During the study, solder paste printing process‐related variables, such as solder paste type, stencil type, and stencil opening ratio, and pick and place process‐related methods, such as vision camera type and vacuum pickup nozzle type were evaluated with the goal of achieving a high‐yield assembly solution for 01005 chip components. A test board was used in a series of designed experiments to optimize the solder paste printing, pick and placement, and reflow processes. Assembly defects were analyzed as a function of the stencil design and the assembly processes.

Findings

The results of the study indicated that both electroformed and electropolished laser‐cut stencils had a comparable print quality with respect to the solder volume delivered to the pads. In terms of assembly yield performance, type 4 (size range: 20‐38 μm) solder paste with a smaller sphere size gave a better overall yield and better paste deposition on the pad, if used on a 0.08‐mm thick electroformed stencil with a 90 per cent aperture. Temperature cycling between −65 and 150°C, with up to 1,500 cycles, showed that no cracks were observed at the solder joints due to temperature cycling. The process and design change required for achieving a robust manufacturing process have been indicated and reported.

Originality/value

The results of this work provide process recommendations for the implementation of 01005‐sized chip components assembly in mass production processes.

Keywords

Citation

Lee, Y., Kim, K. and Suganuma, K. (2011), "Process characterization and reliability for the assembly of 01005 chip components", Soldering & Surface Mount Technology, Vol. 23 No. 4, pp. 235-243. https://doi.org/10.1108/09540911111169084

Publisher

:

Emerald Group Publishing Limited

Copyright © 2011, Emerald Group Publishing Limited

Related articles