Effect of drain cover on entrapment of air while draining a cylindrical vessel

Abstract

Purpose

The objective of the research work is to predict the volume of fluid drained from a cylindrical vessel without entrapping air through the drainpipe, and hence predict the location of the free surface of the liquid in the vessel.

Design/methodology/approach

A two‐dimensional axi‐symmetric numerical simulation has been made using a finite volume method that employs unstructured grids with cell‐wise local refinement and an interface capturing scheme to predict the shape of the free surface of water in a cylindrical vessel, thus simulating the entrapment of air in the drainpipe connected to the vessel.

Findings

A drain cover was placed on top of the drainpipe to delay the entry of air into the drainpipe. It was found that an increase in the diameter of the drain cover increases the amount of liquid to be drained out before the air could enter into the drainpipe. It was found that air enters the drainpipe at a particular height of the liquid in the vessel. However, when an initial rotational velocity was imparted to the liquid, the height of liquid when air enters the drainpipe depends on the initial bath height. As the initial bath height increases, air enters the drainpipe at a progressively higher bath height. But surprisingly when the drain cover is put in place the initial bath height, again, has no effect on the height of the liquid (in the vessel).

Practical implications

The outcome of the present research work has direct implications for steel making. If the drainpipe can be connected to the ladle the way it has been discussed in this paper then more steel can be drained before stopping the drainage in order to avoid air or slag entrapment.

Originality/value

The idea of putting a drain cover, using a larger diameter drainpipe and making the drainpipe connection to the vessel different so as to delay the appearance of air at the drainpipe is a new finding and the idea can be used by steel makers.

Citation

Ajmani, S.K., Mondal, S.S. and Dash, S.K. (2005), "Effect of drain cover on entrapment of air while draining a cylindrical vessel", International Journal of Numerical Methods for Heat & Fluid Flow, Vol. 15 No. 4, pp. 394-414. https://doi.org/10.1108/09615530510590632