To read this content please select one of the options below:

A tensile study of fancy multicount yarn sections

Shakeel Iqbal (Department of Fashion Technology, National Institute of Fashion Technology, Hyderabad, India)
P. Pramanik (Department of Textile Technology, S.G.G.S. Institute of Engineering and Technology, Nanded, India)

Research Journal of Textile and Apparel

ISSN: 1560-6074

Article publication date: 4 December 2017

102

Abstract

Purpose

No study was published about the tensile properties of different sections of multicount yarn. Hence there was a need to conduct a detailed section-wise tensile study of fancy multicounty yarn. The purpose of this study is to identify the different sections of the same multicount yarn and test them separately.

Design/methodology/approach

Multicount yarn with slubs were prepared on a ring frame with the Amsler Textile Effect System. Different yarn sections from each multicount yarn are identified as fine normal, fine slub, medium normal, medium slub, coarse normal, coarse slub and the changeover sections. These sections are tested for the breaking load and breaking elongation. Broken ends of the yarn sections are also studied, and these broken ends are classified as sharp broken end, tapered broken end and slipped broken end. A study is also conducted on the location of break or the place of break at the changeover sections.

Findings

It was found that the twist of yarn at slub sections was lower than the twist at normal sections. In spite of the low yarn twist at slub sections, the breaking load of the yarn was higher at slub sections than at normal sections by 12 to 30 per cent owing to the presence of more number of fibres that share the breaking load. The breaking load at the changeover section (normal to slub and slub to normal) was found to be higher than that at normal section and lower than at slub sections. No significant difference was found between the breaking load of the two changeover sections (normal to slub and slub to normal). The majority of breaks in normal yarn sections were of the tapered broken end type and the majority of breaks in slub yarn sections were slipped broken ends.

Originality/value

Efforts are taken to identify different sections of the same multicount yarn with the help of specially designed square black board and tensile study of these sections are carried out.

Keywords

Citation

Iqbal, S. and Pramanik, P. (2017), "A tensile study of fancy multicount yarn sections", Research Journal of Textile and Apparel, Vol. 21 No. 4, pp. 307-322. https://doi.org/10.1108/RJTA-06-2017-0025

Publisher

:

Emerald Publishing Limited

Copyright © 2017, Emerald Publishing Limited

Related articles