Performance comparison of coated carbide tool under different cooling/lubrication environments during face milling of Inconel-625 and Stainless Steel 304

Abstract

Purpose

This study aims to use nanofluid-based minimum quantity lubrication (NMQL) technique to minimize the use of cutting fluids in machining of Inconel-625 and Stainless Steel 304 (SS-304) (Ni-Cr alloys).

Design/methodology/approach

Machining of Ni-Cr-based alloys is very challenging as these exhibit lower thermal conductivity and rapid work hardening. So, these cannot be machined dry, and a suitable cutting fluid has to be used. To improve the thermal conductivity of cutting fluid, multi-walled carbon nanotubes (MWCNTs) were added to the soybean oil and used with MQL. This study attempts to compare tool wear of coated carbide inserts during face milling of Inconel-625 and SS-304 under dry, flooded and NMQL conditions. The machining performance of both materials, i.e. Inconel-625 and SS-304, has been compared on the basis of tool wear behavior evaluated using scanning electron microscopy-energy dispersive spectroscopy.

Findings

The results indicate higher tool wear and lower tool life during machining of Inconel-625 as compared to SS-304. Machining of Inconel-625 exhibited non-consistent tool wear behavior. The tool failure modes experienced during dry machining are discrete fracture, cracks, etc., which are completely eliminated with the use of NMQL machining. In addition, less adhesion wear and abrasion marks are noticed as compared to dry and flooded machining, thereby enhancing the tool life.

Research limitations/implications

Inconel-625 and SS-304 have specific applications in aircraft and aerospace industry, where sculptured surfaces of the turbine blades are machined. The results of current investigation will provide a rich data base for effective machining of both materials under variety of machining conditions.

Originality/value

The literature review indicated that majority of research work on MQL machining has been carried out to explore machining of Ni-Cr alloys such as Inconel 718, Inconel 800, AISI4340, AISI316, AISI1040, AISI430, titanium alloys, hardened steel alloys and Al alloys. Few researchers have explored the suitability of nanofluids and vegetable oil-based cutting fluids in metal cutting operation. However, no literature is available on face milling using nanoparticle-based MQL during machining Inconel-625 and SS-304. Therefore, experimental investigation was conducted to examine the machining performance of NMQL during face milling of Inconel-625 and SS-304 by using soybean oil (vegetable oil) with MWCNTs to achieve ecofriendly machining.

Citation

Singh, P., Dureja, J.S., Singh, H. and Bhatti, M.S. (2019), "Performance comparison of coated carbide tool under different cooling/lubrication environments during face milling of Inconel-625 and Stainless Steel 304", World Journal of Engineering, Vol. 16 No. 2, pp. 287-295. https://doi.org/10.1108/WJE-06-2018-0194