Citation
(2012), "Multitest MEMS test and calibration equipment now available for MT9510 pick-and-place test handler", Microelectronics International, Vol. 29 No. 2. https://doi.org/10.1108/mi.2012.21829baa.021
Publisher
:Emerald Group Publishing Limited
Copyright © 2012, Emerald Group Publishing Limited
Multitest MEMS test and calibration equipment now available for MT9510 pick-and-place test handler
Article Type: New products From: Microelectronics International, Volume 29, Issue 2
Multitest, a designer and manufacturer of final test handlers, contactors and load boards used by integrated device manufacturers (IDMs) and final test subcontractors worldwide, has shipped the first Multitest MEMS equipment for the MT9510 pick-and-place test handler to an IDM in the USA. This new combination is based on the two well-established platforms: MT MEMS and MT9510.
The installation is for MEMS gyroscope test and has already been successfully installed. This setup leverages our long-term MEMS test expertise as well as our thorough understanding of the challenges in DUT handling. Thus, the industry-leading positioning accuracy and tri-temp performance of the MT9510 also is now available for MEMS test.
Multitest already has received additional orders for package conversion kits and other systems.
For more information, visit the web site: www.multitest.com/MEMS or www.multitest.com/MT9510XP