To read this content please select one of the options below:

Cracking phenomena on flexible‐rigid interfaces in PCBs under thermo cycling loading

Luciano Arruda (Instituto Nokia de Tecnologia, Manaus, Brazil Universidade Estadual do Amazonas, Manaus, Brazil)
Renato Bonadiman (Instituto Nokia de Tecnologia, Manaus, Brazil)
Josineto Costa (Instituto Nokia de Tecnologia, Manaus, Brazil Universidade Federal do Amazonas, Manaus, Brazil)
Tommi Reinikainen (Instituto Nokia de Tecnologia, Manaus, Brazil)

Circuit World

ISSN: 0305-6120

Article publication date: 15 May 2009

414

Abstract

Purpose

The purpose of this paper is to develop simulation models for flexible‐printed circuit boards' flex‐rigid interfaces and to perform experimental tests in the laboratory in order to evaluate the cracking phenomena when these devices are submitted to thermal cycling.

Design/methodology/approach

A device was proposed in order to evaluate the reliability of flex‐rigid interconnections. Thermal cycling tests were performed in an environmental chamber and failure mechanisms investigated using optical and scanning electron microscope techniques. The failure modes were analyzed using computational modelling via the finite element method.

Findings

Through failure analysis, it was observed that device design and thermal expansion/contraction could contribute to the occurrence of high stresses in the copper pad connections. The simulation model proposed was able to identify the critical regions, as they had occurred in the tests. Thus, the qualitative approach may be considered successful enough to be applied in the early stages of design.

Research limitations/implications

The materials proprieties were considered as being linear. Thus, in order to enhance the simulation models to provide a quantitative model for the evaluation of product life, non‐linear (visco‐elastic) behaviour in the material properties and a fracture model should be considered.

Originality/value

Typical causes of cracking failure in electronic devices are related to mechanical stress, moisture, heat from transportation and field use. Thus, finite element analysis is an important tool in order to evaluate the reliability of electronic components regarding these types of loads in the early stages of design.

Keywords

Citation

Arruda, L., Bonadiman, R., Costa, J. and Reinikainen, T. (2009), "Cracking phenomena on flexible‐rigid interfaces in PCBs under thermo cycling loading", Circuit World, Vol. 35 No. 2, pp. 18-22. https://doi.org/10.1108/03056120910953277

Publisher

:

Emerald Group Publishing Limited

Copyright © 2009, Emerald Group Publishing Limited

Related articles