An FEM framework for modeling forces between NdFeB magnets and HTS bulks

Abstract

Purpose

This paper aims to introduce an alternative for modeling levitation forces between NdFeB magnets and bulks of high-temperature superconductors (HTS). The presented approach should be evaluated through two different formulations and compared with experimental results.

Design/methodology/approach

The T-A and H-ϕ formulations are among the most efficient approaches for modeling superconducting materials. COMSOL Multiphysics was used to apply them to magnetic levitation models and predict the forces involved.The permanent magnet movement is modeled by combining moving meshes and magnetic field identity pairs in both 2D and 3D studies.

Findings

It is shown that it is possible to use the homogenization technique for the T-A formulation in 3D models combined with mixed formulation boundaries and moving meshes to simulate the whole device’s geometry.

Research limitations/implications

The case studies are limited to the formulations’ implementation and a brief assessment regarding degrees of freedom. The intent is to make the simulation straightforward rather than establish a benchmark.

Originality/value

The H-ϕ formulation considers the HTS bulk domain as isotropic, whereas the T-A formulation homogenization approach treats it as anisotropic. The originality of the paper lies in contrasting these different modeling approaches while incorporating the external magnetic field movement by means of the Lagrangian–Eulerian method.

Citation

Homrich, G., Ferreira Flores Filho, A., Eckert, P.R. and Dorrell, D.G. (2024), "An FEM framework for modeling forces between NdFeB magnets and HTS bulks", COMPEL - The international journal for computation and mathematics in electrical and electronic engineering, Vol. ahead-of-print No. ahead-of-print. https://doi.org/10.1108/COMPEL-10-2023-0526