Soft actuator using sponge units with constrained film and layer jamming

Abstract

Purpose

This paper aims to propose a soft actuator that combines a sponge-based actuating structure and a layer-jamming-based stiffness-improving structure in a cavity.

Design/methodology/approach

The proposed soft actuator consists of film-constrained sponge units (FCSUs) and jamming layers. The FCSUs in the proposed soft actuator bend under vacuum pressure, causing bending deformation of the entire actuator. The jamming layers are strongly coupled through friction under vacuum pressure, increasing the stiffness of the entire actuator. The performance of the proposed soft actuator was examined by measuring its stiffness, bending deformation and response performance. A four-finger soft robotic gripper was proposed based on the proposed soft actuator.

Findings

Through experiments, it was shown that the proposed soft actuator exhibited acceptable bending deformation, stiffness and response. Moreover, the proposed four-finger soft gripper could effectively grasp objects in daily life.

Originality/value

In this study, the authors proposed a novel bending actuator (with a volume of approximately 43.2 cm³) based on FCSUs and jamming layers. To the best of the authors’ knowledge, this is the first study to combine a sponge-based actuating structure and a layer-jamming structure in a cavity to achieve simultaneous change in actuation and stiffness. The soft actuator exhibited good bending deformation and high stiffness simultaneously under vacuum pressure. Consequently, it could be used effectively to fabricate soft grippers.

Citation

Liu, X. and Liang, Z. (2022), "Soft actuator using sponge units with constrained film and layer jamming", Industrial Robot, Vol. 49 No. 4, pp. 616-624. https://doi.org/10.1108/IR-12-2021-0299